Pro 600 Gen II V8 Complete Harness


The FuelTech PRO600 V8 plug and play harness is the best link between your FT600 ECU and V8 engine. It comes pre-terminated to suit a V8 engine with all relays and fuses for a simple 3 wire battery hook up and ignition power. It has a 37 pin firewall connector to make installation an easy task and with the modular construction, adding a second set of injectors or individual coils is as easy as connecting add-on harnesses utilising the built in output connectors. Each connector has its own label and the connectors and harness insulation is heat, moisture and oil resistant.
PRO600 GEN II V8 Complete Harness Manual
PRO600 Connectors

Now Featuring:
✅ 2 Powered FT CAN connectors interior and exterior.
✅ EGT-8 CAN ready for easy installation.

SKU: N/A Category:


PRO600 GEN II V8 Complete Harness is a harness designed to install a FuelTech FT600 on mostly any racing V8 application. It comes setup for 8 EV1 injectors and can support 16 EV1 injectors using an optional secondary adapter harness
It has most of the engine sensors pre-wired: TPS, hall and VR crank trigger, hall and VR cam sync, fuel pressure, oil pressure, wastegate pressure, turbo back pressure, coolant and intake air temperature and more
It can be used directly with a distributor type ignition or with additional auxiliary coil harnesses to have coil per cylinder ignition such as smart coils or the FuelTech FTSPARK CDI unit with an additional harness
This harness is setup for two Nano wide band o2 conditioners and two o2 sensors. You can also use an additional adapter for a dual channel Alcohol o2 with NTK o2 sensors (requires Bosch to NTK adapters)
There is an INPUTS connector to custom wire up to 13 additional input channels for the engine or chassis datalogging (i.e. driveshaft RPM, trans brake button, suspension travel sensors, input shaft RPM, staging button and much more)
There are 3 additional OUTPUTS connectors to wire custom outputs like wastegate boost control solenoids, trans brake solenoid, dump and lockup valves, gear shift, nitrous stages and more
*In order to wire the additional INPUTS & OUTPUTS terminated in this harness, you must order this harness with the optional mating connector kits.

1 PRO600 GEN II V8 Complete Harness
1 Operation and installation guide


Click Here to Watch the New Pro600 Gen II V8 Complete Harness 

Additional information

connector kits for extra I/O

with mating connector kits, without mating connector kits

Cylinder Numering

Chevy/Chrysler, Ford


There are no reviews yet.

Be the first to review “Pro 600 Gen II V8 Complete Harness”

Your email address will not be published. Required fields are marked *